08
Function
(Opening Screen)
MENU 1
Press t
he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by button
Select the function
by button
Press t
he button
* When the direct call button is set,
the setup screen is also called by the
following method:
Servo view "SERVO"
100% position100% position
1
When ending servo operation checks, return to the initial
screen by pressing the (END) button twice (for direct selec-
tion, press the (END) button once).
Ending the "SERVO" screen
Steering operation
Throttle operation
Channel 3 operation
Servo View "SERVO"
Servo operation of each channel can be checked. Operation of the steering angle adjust-
ment, when a mixing function was set, etc. can be easily checked. The servo view can
also be displayed on the initial screen by using the system function (See page 98).
The neutral position of the throttle channel varies depending on the modes defined by
the "THR-MODE". The screen shown below shows an example of "F50/B50" in the
"NORMAL" mode.
To Next Page
Loading...
