or
The highlighted item is the cur-
rently selected function.
38
Function Map
Custom Menu
A menu matched to the purpose (custom menu) can be created by using the menu cus-
tomize function.
A different menu can be created for each model memory.
1
Call the menu screen from the initial screen by (JOG) button
up, down, life, or right operation.
2
Use the (+) button to Select the MENU1 or MENU2 screen
too be edited.
3
Press the (-) button for about 1 second. A confirmation beep
is generated and the menu customize screen is displayed.
4
Select the location where the function is to be assigned or
modified by moving the cursor by (JOG) up, down, left, or
right operation.
5
Use the (+) or (-) button to select the function to be assigned.
6
When assignment is complete, end by returning to the menu
screen by pressing the (END) button.
Menu assignment
Note:
This function consists of 3 fixed functions; *M-SEL (model select), *M-RES
(model reset), and * MENU-T (menu type select), and cannot be moved or de-
leted.
One point
This function allows modification of the menu list and
addition (except LEVEL3) or removal of functions. All
the functions can also be grouped at MENU1 only de-
pending on the purpose.
When the menu type is changed from the created customize menu to another
menu type by * MENU-T, the customize menu is reset and the menu is initial-
ized to the original menu.
The set values of a function deleted from the menu remain valid. When an un-
used function is turned OFF or rate adjustment, etc. related to other functions is
performed, check the set values before deleting the function.
To Next Page
Loading...
