FUTABA 3PKS - Before Using; Handling the RF Module; Synthesizer RF Module Setup

26
Before Using
Synthesizer RF module PK-FSM
Perform the following frequency setting with the transmit-
ter power switch in the OFF position.
Frequency band setting
1
Using the accessory mini screwdriver, set the digital
switch (x10 side) at the left side of the module to the tens
digit of the band No. you want to set.
2
Next, set the right side digital switch (x1 side) to the units
digit of the band No. you want to set.
3
Confirm that the receiver band matches the band above,
then set the power switches to ON in transmitter and re-
ceiver order.
4
Confirm that the system operates normally.
Inserting the RF module
1
Insert the module while being careful that the
transmitter side connector pins are not bent.
2
Push in the module until the tabs engage with a
"click".
3
Slide on the RF module cover.
RF module cover
Removing the RF module
1
Remove the RF module cover by sliding it in the
arrow direction.
2
Remove the module by pulling it upward while
pushing the left and right tabs to the inside.
Handling the RF Module
RF module temperature rise
"x10"
Channel No.
tens di
g
it
"x1"
Channel No.
units di
g
it
During transmitter use, the temperature of the RF module may rise. This is normal.