42
Function
(Opening Screen)
MENU 1
Press t
he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by button
Press t
he button
* When the direct call button is set,
the setup screen is also called by the
following method:
Function
Modulation ( HRS.PCM.PPM ) Select "P-MOD"
Modulation ( HRS.PCM.PPM ) Select "P-MOD"
Receiver
When using an FM receiver set to the PPM side, when using a PCM receiver, set to the
PCM side and when using an HRS receiver, set to the HRS side.
- When the mode was changed and when a model of a different mode was
selected, signals are output in the mode set at the point at which the
transmitter power was turned back on.
At mode selection, the box cur-
sor moves.
Mode currently operating.
Mode
PPM, PCM, HRS
Mode currently set in memory.
The signal is output in the new mode when the transmitter pow-
er is turned on again.
The signal mode output from the transmitter can be changed. (PPM/PCM/HRS)
1
(Mode selection)
Select the mode to be set by (JOG) button left or right opera-
tion. Selected by moving the box cursor.
2
(Writing to memory)
Press the (+) and (-) buttons simultaneously for 1 second.
- The "MEMORY" display is switched.
3
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
HRS/PCM/PPM mode selection
Mode selection
- Select by (JOG) button left or
right operation.
To Next Page
Loading...
