ｉ
Caution
18
Before Using
Ni-cad Battery Replacement
The Ni-cad battery is connected by a connector so that it can be removed when you will
not be using the transmitter for a long time, or when replacing a dead battery with a
spare battery.
• Always use an NT8F7000B Ni-cad battery.
Ni-cd battery
NT8F700B
Removal
1
Slide the transmitter battery cover in the ar-
row direction while pressing the part shown
in the figure.
2
Remove the Ni-cad battery and disconnect
the connector.
Battery cover
While pressing here Battery cover
Charging
1
Plug the transmitter cord of the special char-
ger into the charging jack on the rear of the
transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
AC outlet
Charger
Transmitter charging
LED
Cord to transmitter
charging jack
Charging the Ni-cad Battery
ｅ
Pay full attention so that the battery cover wouldn't pinch the cable
of the Ni-cad battery.
Pinching the cable by the battery cover can lead to an electrical shortage, fire and
abnormal heat generation, which may cause burns and fire disaster.
To Next Page
Loading...
