FUTABA 3PKS - Reference; Transmitter and Receiver Ratings

10
9
Reference
Reference
Ratings
Transnitter T3PKS
(Wheel system, 3 channels)
- Transmitting frequencies 27, 29, 40, 41 or 75MHz band
(TZ-FM or PK-FMS RF module used)
- Modulation FM
(HRS/PCM/PPM switching possible)
- Power requirement
(Ni-cad battery)
NT8F700B Ni-cad battery (9.6V)
(Dry cell battery)
Penlight x 8 (12V)
-
Current drain 250mA or less (Vibration and back lilighting :off)
Receiver R113iP
(3 channels, PCM receiver)
- Receiving frequencies 27, 29, 40, 41 or 75MHz band
- Intermediate frequency 455kHz
- Power requirement 4.8V or 6V
(shared with servos)
- Current drain 18mA
- Size 42.7x28.7x16.0mm (1.69x1.13x0.63in)
- Weight 21g (0.74oz)
Receiver R203HF
(3 channels, HRS receiver)
- Receiving frequencies 27, 29, 40, 41 or 75MHz band
- Intermediate frequency 455kHz
- Power requirement 6.0V
(shared with servos)
- Current drain 14mA
- Size 25.6x37.7x14.3mm (1.01x1.48x0.56in)
- Weight 17g (0.6oz)
*Specifications and ratings are subject to change without prior notice.
Receiver R303FHS
(3 channels, PPM/HRS receiver)
- Receiving frequencies 27, 29, 40, 41 or 75MHz band
- Intermediate frequency 455kHz
- Power requirement 6.0V
(shared with servos)
- Current drain 95mA
- Size 27.6x39.5x14.5mm (1.09x1.56x0.57in)
- Weight 17g (0.6oz)
ｉ
Caution
ｅ
When using the T3PKs in the high response system (HRS) mode, always use it under the follow-
ing conditions:
Receiver: R203HF, R303FHS or other high response system (HRS) compatible receiver
Servos : 6V Futaba digital servo
Battery : 6V NiCd battery
Transmitter mode : HRS mode (See p.42 for setting method.)
If the conditions are different, control is impossible.
And Fail Safe Unit (FSU) is not available.