MEMORY MODULE
INITIALIZE ?
YES > +
NO > -
20
Before Using
Initialization
When using the CAMPac-16K, initialization is necessary so
that the CAMPac-16K can be used with this transmitter. When
"INITIALIZE?" is displayed on the screen at power ON, press
the (+) button. This automatically initializes the CAMPac-16K.
No further action is necessary.
When a CAMPac-16K used with another model has been inserted, and initialization is
executed by pressing the (+) button when "INITIALIZE?" is displayed on the screen at
power ON, the old data is destroyed so the CAMPac-16K can be used with the T3PKS.
CAMPac-16K Memory module
The optional CAMPac-16K increases your model storage capability (to 30 modelsfrom
20) and allows you to transfer programs to another T3PKS transmitter. Note that data
may not be transferred to/fromany other model of transmitter (T3PK, T3VCS, etc).
CAMPac-16K
(Optional)
CAMPac slot
When inserting and removing the CAMPac-16K
Always turn off the transmitter power before removing or inserting the CAMPac-16K.
LCD screen:
Audible alarm:
Tone sounds (7 times)
and stops (repeated)
Model Select Error
If the power is turned back on in the state in which a model memory in the CAMPac-
16K was called and the CAMPac-16K is not installed, an audible alarm will sound and
"SELECT ERROR" will be displayed on the LCD screen. When any button is pressed,
model 1 will be forcibly called.
Always turn off the transmitter power before
installing and removing the CAMPac-16K.
Removal Precautions
To Next Page
Loading...
