Setting item
MODE :Speed type selection
LOW :Low side range speed
adjustment
MID :Medium speed range
speed adjustment
HIGH :High side range speed
adjustment
TGP1 :Low and medium speed
switching point
TGP2 :Medium speed and high
switching point
Setup item selection
- Select by (JOG) button up or
down operation.
61
Function
Use SW1, SW2, SW3 to switch the throttle speed function ON/OFF.
See the function select switch function (See page 79).
Switch setting
Throttle Speed "THSPD"
Adjustment method for 3 SPEED
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Initial value
LOW, MID, HIGH :"100"
TGP1 :30
TGP2 :60
Speed type Select button
- Select with the (+) or (-) but-
tons.
When a value of 99 or less is set
at either LOW or HIGH, the dis-
play is switched from OFF to ON
by trigger operation.
The LOW and HIGH ranges
are linked with the TGP1 set
point and displayed.
Throttle trigger position
Adjustment range
LOW :1~100
HIGH :1~100
At 100%, there is no delay.
TGP1 :1~100
(Preparation)
- Select the setting item "MODE" by (JOG) button up or down
operation. Press the (+) or (-) button and select "3 SPEED".
1
("LOW", "MID", and "HIGH" delay adjustment)
Select the setting item "LOW", "MID", or "HIGH" by (JOG)
button up or down operation.
2
(Speed switching point adjustment)
When you want to change the "LOW", "MID", and "HIGH"
switching point, select setting item "TGP1" or "TGP2" by
(JOG) button up or down operation.
3
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
The steering speed adujustment
"
LOW
", "
MID
"
,
"
HIGH
"
can be controlled with digital
dial DL1, DL2, DL3 or digital trim DT3 etc. with the function select dial function. (See
page 80)
Dial / Trim Setting
To Next Page
Loading...
