Setup items
ATS : READY setting
TG.P : Throttle position
PRST : Preset position
MODE : Function selection
Setup item selection
- Select by (JOG) button up or down operation.
63
Function
-If the throttle trigger is moved to the set position while "READY" is flashing, the throt-
tle servo will move to the set position. The throttle operation wait state is reset when the
throttle trigger is returned.
-When using the Start function, always set the function by performing step 3 above each
time.
Start Function, Engine Cut "START"
(Preparation)
- Select the setting item "MODE" by (JOG) button up or down
operation. Press the (+) or (-) button and select "AT&SW".
- Select setup item "TG.P" and make the following adjustments.
1
(Throttle position setup)
Set the throttle position by pressing the (+) or (-) button.
2
(Preset position setup)
Select the setting item "PRST" by (JOG) button up or down
operation, and use the (+) and (-) buttons to set the preset
position of the throttlle servo.
"B100" ~ "B1" : Brake side
"0" : neutral
"F1" ~ "F100" : Forward side
Setting Example: (When amp used with an electric car)
Set the preset position to F75% at EPA100%.
3
("READY" setting)
Select the setting item "ATS" by (JOG) button up or down op-
eration, and press the (+) and (-) buttons simultaneously for
about 1 second. "READY" blinks on the screen and the sys-
tem enters the READY state. Trottle trigger operation starts
the function.
4
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
Start function adjustment
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Setup item selection
- Select by (JOG) button up or
down operation.
READY setting (ATS)
OFF : off state
READY: Ready state
ACT : on state
Preset position (PRST)
B100 ~ B1, 0, F1 ~ F100
Initial value: 0
Trigger position (TG.P)
5 ~ 95
Initial value: 5
To Next Page
Loading...
