FUTABA 3PKS - Function; Programmable Mixes 1 & 2 (PMIX1, 2) (Continued)

77
Function
Programmable Mixes1, 2 "PMIX1, 2"
(Preparation)
- Use the function select switch function (page 79) to select the
switch. (as desired)
1
(Mixing function ON/OFF)
Select the setting item "MODE" by (JOG) button up, down,
left, or right operation. Press the (+) or (-) button and set the
function to the "ACT" state.
"INH" :Function OFF
"ACT" :Function ON
2
(Master channel)
Select setup item "MST" by (JOG) button up, down, left, or
right operation, and select the master channel by pressing
the (+) or (-) button.
3
(Slave channel)
Select setup item "SLV" by (JOG) button up, down, left, or
right operation, and select the slave channel by pressing the
(+) or (-) button.
4
(Left, forward or up side mixing amount adjustment)
Select the setting item "LEFT", "FWRD", or "UP" by (JOG)
button up, down, left, or right operation. Use the (+) or (-) but-
ton and adjust the right, brake, or down side mixing amount.
5
(Right, brake or down side mixing amount adjustment)
Select the setting item "RGHT", "BRAK", or "DOWN" by (JOG)
button up, down, left, or right operation. Use the (+) or (-) but-
ton and adjust the right, brake, or down side mixing amount.
6
(Offset amount setup)
Select setup item "OFS" by (JOG) button up, down, left, or
right operation, and use the (+) and (-) button to adjust the
offset amount.
7
(Mixing mode setup)
Select setup item "MXD" by (JOG) button up, down, left, or
right operation, and use the (+) or (-) button to select the
mixing mode.
"OFF" :Mixing proportional to master channel operation.
"MIX" :Mixing by master channel another function considered.
8
(Trim mode setup)
Program mixing adjustment
Mixing amount
-100~0~+100
Initial value: +50
Function ON/OFF (MODE)
INH, ACT
Channel selection (MST)
ST, TH, CH3
Initial value :PMIX1(ST)
PMIX2(TH)
Mixing mode (MXD)
OFF, MIX
Initial value: OFF
Switch
PRG MIX1 : Program mixing 1
PRG MIX2 : Program mixing 2
Channel selection (SLV)
ST, TH, CH3
Initial value :PMIX1(TH)
PMIX2(CH3)
Mixing amount
-100~0~+100
Initial value: +50
Offset amount (OFS)
-100~0~+100
Initial value: 0
Setup item selection
- Select by (JOG) button up,
down, left or right operation.