FUTABA 3PKS - Function; Timer Function (TIMER) (Continued)

To Next Page

To Previous Page

Function

Timer Function "TIMER"

(Preparation)

Select the setting item "TYPE" by (JOG) button up or down

operation. Press the (+) or (-) button and select "LAP NEMO-

RY".

(Alarm time setting)

Select the setting item "ALRM"by (JOG) button up, down,

left, or right operation and set

the alarm time with the (+) and

(-) buttons.

(Pre alarm time setting)

Select the setting item "PRAL"

by (JOG) button up, down, left, or right operation, and set the

pre alarm time with the (+) and (-) buttons.

(Timer start/lap count operation)

Perform the start and lap count operations with the switch

("LAP START") assigned by

function select switch function.

- Linking only start to the throt-

tle trigger

Select the setting item "RST" by (JOG) button up, down, left,

or right operation and press the (+) and (-) buttons simultane-

ously for about 1 second. The set beeps and the timer display

changes from "RST" to blinking "RDY" and the set enters the

trigger operation ready state. (Status display "RUN")

(Timer stop/reset operation)

When the lap count switch ("LAP START") is pressed after

the time set with "ALRM" has

elapsed, the timer stops and

the lap time, total time, and av-

erage time are memorized.

When the switch ("LAP RE-

SET") is pressed, the timer is reset.

When a switch is not assigned, select the status display

("RUN", "STP", or "RDY") by (JOG) button up or down opera-

tion and press the (+) or (-) buttons simultaneously for about

1 second. The set beeps and the timer display changes to

"RST" and the timer resets.

- When the timer was stopped with the switch assigned the “LAP RESET”

function before the set “ALRM” time has elapsed, the total time and av-

erage time are not memorized.

Using the Lap timer timer

Adjustment buttons

- Use the (+) and (-) buttons to

make adjustments.

- Press the (+) and (-) buttons

simultaneously (approx. 1 sec)

to return to the initial screen.

Switches

LAP START :start / lap count

LAP RESET :stop / reset

Alarm time (ALRM)

OFF, 1 ~ 99 m

Initial value: 8 m

Prealarm time (PRAL)

OFF, 1 ~ 30 s

Initial value: OFF

Status display

RST :Reset state

RDY :

Throttle trigger operation wait

RUN :Timer running

STP : Timer stopped