FXO GATEWAY - Page 106

FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
104
-method download via TFTP/FTP (TFTP: mode=0, FTP: mode=1)
-ftp specify username and password for FTP
Note:
This command can run select one option in 'app', 'dsptest', 'dspcore',
'dspapp', and 'rbpcm'.
Example:
rom -method 1
rom -ftp vwusr vwusr
rom -app -s 192.168.4.101 -f app.bin
Parameter Usages:
-print show versions of all rom files
-app, boot, dsptest, dspcore, dspapp to update main Application
program code, Boot code, DSP
testing code, DSP kernel code,
or DSP application code.
-boot2m boot2m parameter let users to upgrade the whole system
flash, including all the firmware that mentioned above. If 2M
rom file update is executed, users have to set again the
MAC address of FXO GateWay or it will cause conflict
on Ethernet because the original MAC address is erased
during 2M ROM file upgrading.
Note: To set mac address please key in command setmac:(when key in
MAC address ,press enter each time after key in two characters):
-------------------------------------------------------------------------------------------------
usr/config$ setmac
- enter mac address (xxxxxxxxxxxx):
0001a8002baa
- the mac address is 00 01 a8 00 2b aa
- if mac address is correct,please press 'y' to
setup configuration,else press 'n' to continue
y
-------------------------------------------------------------------------------------------------
-greeting The greeting file can be updated by users. The attributes of