FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
68
4.2.4 [reboot]
After commit command, type reboot to reload FXO GateWay in new
configuration. The procedure is as below:
usr/config$ reboot
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
AC4804[0] is OK
AC4804[1] is OK
AC4804[2] is OK
Successful
Initialize OSS libraries...OK!
open stack successful
cmInitialize succeed!
GK mode selected.
login:
4.2.5 [flash]
This command will clean the configuration stored in the flash rom and
reboot FXO GateWay in factory default setting.
Parameter Usage:
-clean clean all the user-defined value, and reboot FXO GateWay
in factory default mode.
Note: It is recommended that use “flash –clean” after application firmware
id upgraded.
Warning: Once users execute flash –clean, all the configurations of FXO
GateWay will be cleaned. This can only be executed by user who log in with
root
To Next Page
Loading...