FXO GATEWAY - Line]

FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
79
1719, is well-known port for RAS communication.
-h225 to specify H.225 RAS port number.
-q931 to specify H.225 signal port number.
-dstq931 to specify destination H.225 signal port number.
-range To allocate port range (1500-65535) Gateway may use it.
-respto Maximum response time out
-connto Maximum connection time out
Note: From –rtp to –conneto commands are for advanced users, please
do not change the default settings if not necessary.
4.2.12 [line]
This command is for configure each line parameters of Gateway.
-------------------------------------------------------------------------------------------------
usr/config$ line
Gateway line information and configuration
Usage:
line [-print][-config number [hunt number][hotline number]
line -print Gateway line information.
-config Set Gateway line information.
hunt: Hunting group.
hotline: Hot line configuration.
Example:
line -config 1 hunt 1 hotline 1003
usr/config$
Parameter Usages:
-print print out all current settings of line
-config determine which line to configure
-hunt set hunting group flag of each line. User can assign different
hunt group number represent different hunt group. For
example, if user assigns FXS TEL1 as hunt group 1, and FXS
TEL2 as hunt group 2, they will be determined as 2 different
groups. On the other hand, if user assigns FXS TEL1 as hunt
group 1, and FXS TEL2 as hunt group 1 too, when having