FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
71
-timezone set local time zone according to GMT
-ipsharing Just put the static IP address for the WAN port of the IP
sharing if the gateway is behind this IP sharing device.
-ipchange If the unit is behind the IP sharing device and the IP address
for the WAN port of that IP sharing is using the dynamic IP
address. This function has to be enabled.
usr/config$ ifaddr –ipchange 1
-id This id is for the user name of the PPPoE usage.
-pwd This password is for the user name of the PPPoE usage.
-reboot If the connection disconnected by the ISP, the unit will
reboot and get the ip again.
4.2.8 [time]
When SNTP function of FXO GateWay is enabled and SNTP server can
be found as well, type time command to show current network time.
usr/config$ time
Current time is THU JUL 01 11:46:01 2004
Please make sure about that the SNTP server was configured before you
used this command.
4.2.9 [ping]
Use ping to test whether a specific IP is reachable or not.
For example: if 192.168.1.2 is not existing while 210.63.15.32 exists.
Users will have the following results:
usr/config$ ping 210.54.23.129
PING 210.54.23.129: 56 data bytes
Please contact with your vendor before you are using the ipsharing and
ipchange function.
To Next Page
Loading...