FXO GATEWAY - Prefix]

FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
80
incoming call to FXS TEL1, which is busy, this call will be
route to FXS Line2.
Note: FXO Lines and FXS TELs are treated as 2 different
groups, so even they are in the same hunt group, call will only
be routed to the same FXS or FXO Lines.
-hotline set hotline table.The Hotline Mode is applied in limited two
channels. User just picks up the phone set of one FXS TEL or
calls in one FXO line, and gateway will automatically dial out
a phone number. In the other hand, user will hear ring back
tone or dial tone immediately depended on configurations of
destination device. Note: This function can both work in
GK or P2P mode.
GK Mode Usage:
Set gateway under gk mode.
Create a Hotline table with “line ” command.
usr/config$ line –config 1 hotline 1001
In this example means: if user calls in FXO Line1, gateway
will automatically dial out “1001”.
P2P Mode Usage:
Set gateway under P2P mode.
Create phone book table with “pbook ” command.
Create a Hotline table with “line ” command.
usr/config$ pbook –add name test ip 10.1.1.1.e164 1001
usr/config$ line –config 1 hotline 1001
In this example means: if user calls in FXO Line1, gateway
will automatically dial out IP address of “1001”.
4.2.13 [prefix]
This command is for make rules for drop or insert prefix digits.
----------------------------------------------------------------------------------------------
usr/config$ prefix