FXO GATEWAY - Change the Default Routing

FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
58
this route table if the prefix number was matched.
 Destination – To decide the destination for this route table.
 E.164 – The E.164 number of the destination.
 Mini Digits – The mini digits requirement for this route table.
 Max Digits – The max digits requirement for this route table.
 Hunt Method – Enable the Hunt Group function and pick up the hunt type.
 NONE : Disable the Hunt Group function.
 GROUP : The Hunt Group function will working for the same group.
User could configure the group in the Line Configuration table.
 ALL : The Hunt Group will working for the same type.
 Add Data – Add a new record for the route table.
 Delete Data – Delete a record for the route table.
 Change Default – Change default route table.
3.21.1 Change the default routing
Please follow up the steps if you want to change the default routing:
1 Pick up the side for the incoming calls and define the destination of this side.
Press the Change Default to save the data.
None – Disable this function
Group – The call will search other ports to be the destination with the same
group if the origin destination is busy.
A
ll – The call will search other ports to be the destination with the same type i
f
the origin destination is busy.
A
bout the Group setting, Please get more info from the Line Configuration.