FXO GATEWAY - Tone]

FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
91
This command means if gateway has incoming call’s prefix number is
100, and total digits is between 1 to 3, this call will be routed to FXS
TEL 1001, and if TEL 1001 is busy, call will be routed to another FXS
TEL.
2. route –fxo dst 1
This command means incoming call from FXO Lines will be routed to
FXO side.
Note:
(1) If user doesn’t want to determine a specific port to route, e.164
number must set as “x” and the call will be routed to the first port.
(Ex. route –ip dst 1 e164 x)
(2) Default value: Incoming call from FXS and FXO ports will be
forward to IP side.
4.2.19 [tone]
This command is basically for FXO ports.
-------------------------------------------------------------------------------------------------
usr/config$ tone
Disconnect tone and remote ring back tone configuration
Usage:
tone [-print][[num][freqLo ][freqHi ][freqLoLev][freqHiLev]
[Tone1ON][Tone1OFF][Tone2ON ][Tone2OFF ]]
tone -print Display tone configuration.
num Tone index(1~4=Disconnect tone, 5~8=Remote ring back tone).
freqLo Low frequency.
freqHi High frequency.
freqLoLev Low level frequency.
freqHiLev High level frequency.
Tone1ON .
Tone1OFF .
Tone2ON .
Tone2OFF .
Example: