FXO GATEWAY - Page 92

FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
90
route -delete 1
usr/config$
Parameter Usages:
-print print out all routing table information
-add add a routing rule in routing table. User can add less than 50
rules. (route –add prefix “prefix number” dst “destination
port type” e164 “e.164 number of port” min “minimum
digits needed” max “maximum digits can’t be
exceeded”)
-delete delete a routing rule in routing table (route –delete “index of
routing rule”)
-modify modify a routing rule in routing table. (route –modify “index
of routing rule” prefix “prefix number” dst “destination
port type” e164 “e.164 number of port” min “minimum
digits needed” max “maximum digits can’t be
exceeded”)
-ip create routing table for incoming call from IP side. (route –ip
dst “destination port type” e164 “e.164 number of port”)
-fxo create routing table for incoming call from FXO Lines.
(route –fxo dst “destination port type” e164 “e.164
number of port”)
prefix prefix of dialed number
dst destination port, 1 means FXO Lines, 2 means IP side, x
means no determinate number.
e164 destination e.164 number. This only need to be set when
routed port is FXS TELs or FXO Lines to determine which
port will this call be routed to.
min minimum digits needed.
max maximum digits needed.
hunt set hunt method for busy forward. 0 means no hunting, 1
means hunting method follows the rule of [line], 2 means
hunting method is to hunt between all ports in the same type.
Usage Example:
1. route –add prefix 100 dst 1 e164 1001 min 1 max 3 hunt 1