FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
27
DNS primary – To configure the first ip address for the DNS server.
DNS secondary – To configure the second ip address for the DNS server.
HTTP Port – To configure the HTTP port for access this unit from the
remote side.
SNTP – Enable the SNTP server registering function if user wants to get
the correct time from the Command Line Interface.
SNTP Server Address – Enter the correct ip address of the SNTP server
or get the incorrect time from the Command Line Interface.
GMT – Configuring the time area for the time display in the Command
Line Interface.
IP Sharing – Enable this function if the gateway is behind the IP sharing
device.
IP Sharing Server Address – Enter the WAN IP address of the IP sharing
device if it is the fixed ip.
IP Change – Enable this function if the WAN IP address of the IP sharing
device is dynamic address.
PPPoE User Name – To configure the user name for the PPPoE
connection.
PPPoE Password – To configure the password for the PPPoE connection.
PPPoE IP Address – In the PPPoE mode, this table will show the ip
address that this unit gets from the ISP.
PPPoE Destination – In the PPPoE mode, this table will show the default
gateway address that this unit gets from the ISP.
PPPoE DNS primary – In the PPPoE mode, this table will show the DNS
ip address that this unit gets from the ISP.
After Remote Host Disconnection – This unit will reboot and re-connect to
the ISP
EMS Configuration
The IP change function could support the GK from us only. Please pa
To Next Page
Loading...