FXO H.323 Gateway User Manual Document Ver.: 118a
Release Sep, 2004
87
support -print Display support information and configuration.
-t38 T.38(FAX) (0=Disabled, 1=Enabled).
-t38rq T.38(FAX)send request mode.(0=Disable, 1=Enable)
-t38ecm T.38(FAX) ECM (0=Disabled, 1=Enabled).
-t38asn1 T.38(FAX) ASN.1 support (0=Disabled, 1=Enabled).
-faxrdd FAX redundancy depth (0 ~ 2).
-fstart Fast start (0=Disabled, 1=Enabled).
-tunnel H245 Tunneling (0=Disabled, 1=Enabled).
-h245fs H245 message after FastStart support (0=Disabled, 1=Enabled).
-earlyh245 EarlyH245 support (0=Disabled, 1=Enabled).
Example:
support -t38 1
support -t38rq 1
support -t38ecm 1
support -t38asn1 1
support -faxrdd 1
support -fstart 1
support -tunnel 1
support -h245fs 1
support -earlyh245 1
usr/config$
Parameter Usages:
-print print current settings in support command.
-t38 to switch ON/OFF (1 = ON; 0 = OFF) T.38 fax ability. When
T.38 ability is ON, Gateway will automatically defer codec
(G.723 or G.729 series) to T.38 when FAX signal is
detected.
-t38rq The T.38 could support the request mode message sending
or not. 0 for disable the request mode sending and 1 for
request mode sending with the T.38.
-t38ecm to switch ON/OFF (1 = ON; 0 = OFF) T.38 fax Error
Correction Mode ability. When high-speed T.38 FAX is
running, Gateway will automatically execute ECM function.
-t38asn1 Enable the ASN.1 support with the FAX.
To Next Page
Loading...