Gallagher W810 v2 - Page 36

 3E2364WeighScaleW810v2UserManual

Page32

Autodrafter
TheWeighScalecaninterfacedirectlywithautodrafters.Therearesixdrafter
optionsforcommunicatingwiththeconnectedport.
TheWeighScalesendsdraftingcommandstotheautodrafterduringthe
weighingsession.
ToconnectanautodrafterwiththeWeighScale,completethefollowingsteps:
1. TurnontheWeighScale.
2. Ensuretheautodrafteristurnedoff.
3. ConnecttheautodraftertooneoftheportsontheWeighScale.
4. Settheporttotherequiredoption.SeeCommunications(p28)formore
information.
5. Turntheautodrafteron.
Note:Forinformationaboutsettinguptheautodrafterintothree‐waydrafting,see
Draftmenu.(p14)

PowerfeedtoElectronicIDreaders
TheWeighScalecansupplypowertoanElectronicIDreader.Powerissupplied
onlyifthereaderisconnectedtoPort2andifeitheroneoftheElectronicID
readeroptionsisselected.
WithPort2,ifyounominateadeviceotherthananElectronicIDreader,the
powerfeedisdisabledbutcanbemanuallyconfiguredviatheadvancedsetup
menus.IftheElectronicIDReaderyouareusingdoesnotrequirepowerfrom
theWeighScale,youcanconnectittoeitherPort1orPort2.