Configuration
181 · Target and user modules (DP-HR-U)
4. Press F2 to save your settings.
Changing the select keys
In the default settings, the select keys 1 and 2 are active to switch between the con-
nected target modules.
You can also select another set of select keys.
How to select another set of select keys:
1. Press the Alt+Num (default) hotkey to open the on-screen display.
2. Select Hotkey and press Enter.
3. Select Selectkeys and press F8 to select one of the following options:
4. Press F2 to save your settings.
Administrating EDID profiles
The EDID information (Extended Display Identification Data) of a monitor gives the
graphics card of a connected computer information about various technical features
of the device.
The EDID profile of the monitor that is connected to the user module, is not avail-
able at the target module. Therefore, the target module transmits a standard profile
to the computer. The EDID information of the profile are optimised for the majority
of available graphics cards.
ADVICE:
Press Ctrl+F8 to show a list inclduing all options. Select the desired
option and press
Enter.
NOTE:
Select keys can only be used and configured at user modules providing at
least two channels (e.
g. DVI-CON-2).
1, 2: Activates select keys 1 and 2
F1, F2: Activates select keys F1 and F2
NUM 1, NUM 2
Activates select keys NUM 1 and NUM 2
A , B: Activates select keys A and B
ADVICE:
In some cases it is recommended to send the EDID profile of the console
monitor to the target module. Now the connected computer receives the EDID data
of the console monitor.
To Next Page
Loading...
