Custom Avoidances
Custom avoidances allow you to select specific areas or sections of road to avoid. When the device calculates
a route, it avoids these areas and roads unless no other reasonable route is available.
Avoiding a road
1 Select > Navigation > Custom Avoidances.
2 If necessary, select Add Avoidance.
3 Select Add Avoid Road.
4 Select the starting point of the section of road to avoid and select Next.
5 Select the ending point of the road section and select Next.
6 Select Done.
Avoiding an area
1 Select > Navigation > Custom Avoidances.
2 If necessary, select Add Avoidance.
3 Select Add Avoid Area.
4 Select the upper left corner of the area to avoid and select Next.Next
5 Select the lower right corner of the area to avoid and select Next.Next
The selected area is shaded on the map.
6 Select Done.
Disabling a custom avoidance
You can disable a custom avoidance without deleting it.
1 Select > Navigation > Custom Avoidances.
2 Select a created avoidance.
3 Select > Disable.
Deleting custom avoidances
1 Select > Navigation > Custom Avoidances > .
2 Select an option:
• To delete all custom avoidances, select Select All > Delete.
• To delete one custom avoidance, select the avoidance and select Delete.
Navigating off road
If you are not following roadways as you navigate, you can use Off Road mode.
1 Select > Navigation.
2 Select Calculation Mode > Straight Line > Save.
The next route will be calculated as a straight line to the location.
Navigating to your destination 19
To Next Page
Loading...
