Garmin GPSMAP 695 - Power; Setting Airport Criteria

Garmin GPSMAP 695/696 Owner’s Manual
190-00919-00 Rev. D
27
Overview
Overview GPS Navigation Flight Planning Hazard Avoidance Additional Features Appendices Index
POWER
Turning the power loss warning on/off:
1) Press the MENU Key twice to display the Main Menu.
2) Turn or move the FMS Joystick to highlight ‘System Setup...’, and press the
ENT Key.
3) Turn or move the FMS Joystick to highlight ‘Power’ and press the ENT Key.
4) Turn the FMS Joystick to select ‘On’ or ‘Off’, and press the ENT Key.
SETTING AIRPORT CRITERIA
The Page Menu on the Nearest Airports Page allows the pilot to filter out airports
that do not meet a defined criteria. Specific surface types and runway lengths can be
defined, as well as the option to include private airports and/or heliports.
RunwaySurface—allowsyoutosetcriteriaforthetypeofsurfaceontherunway:
• Any—showsanyrunway,regardlessofsurfacetype,includingwaterlanding
facilities.
• HardOnly—showsonlyrunwayswithaconcrete,asphalt,orsimilarsealed
surface.
• HardorSoft—showsallrunwaysexceptwaterlandingfacilities.
• WaterOnly—showsonlywaterlandingfacilities.
MinimumRunwayLength—allowsthepilottoenteraspeciclengthfortheshortest
runway allowed.
Entering airport criteria:
1) Press the NRST Key.
2) Turn the FMS Joystick to select the Nearest Airports Page.
3) Press the MENU Key to display the Page Menu.
4) Turn or move the FMS Joystick to select ‘Set Airport Criteria’, and then
press the ENT Key. The Airport Criteria Window appears with the current
settings.