Garmin GRS 77 - Arrivals

Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
190-02692-00 Rev. A236
FLIGHT MANAGEMENT
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
Removing a departure procedure from the active flight plan:
1) Press the FPL Key to display the Active Flight Plan Page (MFD) or the Flight Plan Window (PFD).
2) Press the MENU Key, and highlight ‘Remove Departure’.
3) Press the ENT Key. A confirmation window is displayed listing the departure procedure.
4) With OK highlighted, press the ENT Key. To cancel the removal request, highlight CANCEL and press the ENT
Key.
Or:
1) Press the FPL Key to display the Active Flight Plan Page (MFD) or the Active Flight Plan Window (PFD).
2) Push the FMS Knob, and turn to highlight the departure header in the active flight plan.
3) Press the CLR Key. A confirmation window is displayed listing the departure procedure.
4) With OK highlighted, press the ENT Key. To cancel the removal request, highlight CANCEL and press the ENT Key.
5) Push the FMS Knob to remove the flashing cursor.
ARRIVALS
A Standard Terminal Arrival (STAR) can be loaded at any airport that has one available. Only one arrival can
be loaded at a time in a flight plan. If an arrival is loaded when another arrival is already in the active flight
plan, the new arrival replaces the previous arrival. The route is defined by selection of an arrival, the transition
waypoints, and a runway.
Loading an arrival into the active flight plan using the PROC Key:
1) Press the PROC Key. The PROCEDURES Window is displayed.
2) Highlight SELECT ARRIVAL.
3) Press the ENT Key. The PROC – ARRIVAL LOADING Page is displayed.
4) Use the FMS Knob to select an airport and press the ENT Key.
5) Select an arrival from the list and press the ENT Key.
6) Select a transition (if required) and press the ENT Key.
7) Select a runway (if required) and press the ENT Key. LOAD? is highlighted.
8) Press the ENT Key to load the arrival procedure.