Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
190-02692-00 Rev. A
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
436
APPENDIX B
An indication of ‘Complete’ still requires a power cycle before the synchronized databases will be used by
the system.
Figure B-12 AUX-System Status Page, Database Window
The Display Database Softkey is used to place the cursor in the Database Window. Upon first press of
the Display Database Softkey, the softkey will change to a selected state (black text on gray background)
and the cursor will appear in the Database Window. At this point the user can scroll through all databases
in the Database Window to view status information. If the Display Database Softkey is pressed repeatedly,
the softkey will switch between PFD1 and MFD1. Database status information in the Database Window
will reflect the database of the selected PFD or MFD. After a successful sync and restart, verify the proper
databases are now in use on the AUX–System Status Page.
If an error occurs during the synchronization, an error message will be displayed, followed by the affected
display in the Sync Status section of the Database Window. If a synchronization completes on one display, but
an error occurs on another, the error message will be displayed with the affected display listed after it. When
an error message is displayed, the problem must be corrected before the synchronization can be completed.
A power cycle is required to restart synchronization when ‘Card Full’ or ‘Err’ is shown.
Figure B-13 Synchronization Error Message
Database
Synchronization Error
Message
Error Message Description
Canceled Database synchronization has been canceled by removing the bottom SD card in
display being updated
Card Full SD card does not contain sufficient memory
Err Displayed for all other errors that may cause the synchronization process to be halted
Timeout System timed-out prior to the database transfer completing
Table B-1 Database Synchronization Error Messages