Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
190-02692-00 Rev. A36
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
Figure 1-23 AUX – UTILITY Page
TIMERS
The generic timer can be set to count up or down from a specified time (HH:MM:SS). When the countdown
on the timer reaches zero, the digits begin to count up from zero. If the timer is reset before reaching zero
on a countdown, the digits are reset to the initial value. If the timer is counting up when reset, the digits are
zeroed.
Setting the generic timer (PFD):
1) Press the
TMR/REF
Softkey.
2) Turn the
large FMS
Knob to select the TIMER Field (00:00:00).
3) Turn the small FMS Knob to enter the desired time (HH:MM:SS) and press the
ENT
Key.
4) With the UP/DN Field highlighted, turn the
small FMS
Knob to select the timer counting direction (UP/DN) and
press the
ENT
Key.
5) With ‘START?’ highlighted, press the
ENT
Key to start the timer. The field changes to ‘STOP?’.
6) To stop the timer, press the ENT Key with ‘STOP?’ highlighted. The field changes to ‘RESET?’.
7) To reset the timer, press the ENT Key with ‘RESET?’ highlighted. The field changes back to ‘START?’ and the
digits are reset.
8) To remove the window, press the
CLR
Key or the
TMR/REF
Softkey.