157
Gateway Micro Tower Case
www.gateway.com
7 Slide the new system board into the keyhole slots and lock it into place
with the thumbscrew.
8 Reconnect the power and data cables using your notes from Step 4. See
the system board documentation for further instructions.
9 Reinstall the add-in cards by following the instructions in “Adding or
replacing add-in cards” on page 147.
10 Close the case by following the instructions in “Closing the case” on
page 134.
Important The new system board must have special standoffs
(
pem studs
) mounted on the bottom of the board. If
necessary, use the standoffs from the original system
board.
To Next Page
Loading...
