GAUI NX4 - Tail Gear Case Assembly

GAUI
TAI SHIH HOBBY CORPORATION
GAUI
TAI SHIH HOBBY CORPORATION
Tail transmission assembly-2
Tail gear case assembly
༉୞׏ᆔಣ၇.3
Κᡞԓ׏෧ಣ၇
23
M2x8........................x1
N3x5.5L
ۢ՞Ѝ
M3x6
M3x6
M3x6
M3x3
M3x12
M2x8
B5x11x4
ڿۢᘉ
Position point
Tail gear case cover
׏ໆ
Tail Output Shaft
Position hole
Κᡞԓ׏෧ᇑ
Κᡞԓ׏෧
Κᡞԓ׏෧ಹ࣑
B5x11x4
1.Fix the M2x8 screw into the
bevel gearDQG¿[WKH0[
screw with M3x3 set screw.
2/஡N3y9ᖴ๜ᚈΤᏐໆٯ஡
!!N4y4ᖴ๜ᚈΤ׏ໆȂڿۢN3y9Ȅ
Assemble the tail support
clamp and tail control rod,
insert the front drive gear into
the tail boom.
஡׏ᆔַІܝఝ৵ဋΤ׏ᆔȂ
ٯ৉αࠊ༉୞ᏐᎉጒȄ
M3x6
Rudder Control Guide
B12x18x4
17T Bevel Gear (Front)
Tail Support Clamp
ܝఝ৵
׏ᆔַ
Front Drive Gear
ࠊ༉୞Ꮠᎉጒ
28U!ࠊ༉୞Ꮠᎉ
B12x18x4
17T Bevel gear
Tail Rotor Control Arm Mount
ࠊ༉୞Ꮠᎉ
Bearing 12x18x4.........x2
M3x6...........................x2
Bearing 12x18x4.........x2
Bearing 5x11x4...........x2
M3x6...........................x4
M3x12.........................x1
M3x3...........................x1
N3x5.5L......................x1
B12x18x4
Integrated Tail Gear Case Assembly
M3x6
ᖴ๜ְሰαЦྥᏙ
All screws should be applied with
thread lock.
B12x18x4
ᖴ๜ჭб
Countersunk Washer
ᖴ๜ჭб
Countersunk Washer