GBA ST1 - User Manual

GBA Global Bill Acceptors GBA ST1 Operation Manual
Page 1 of 37 Astrosys International Ltd
September 2011
ST1 Operations Manual Rev 2.0
GBA ST1
Operation Manual
This document is the copyright of Astrosys International Ltd. and may not be reproduced in total or in part
by any means, electronic or otherwise, without the prior written consent of Astrosys International Ltd.

Summary

2.0 PRODUCT INFORMATION

2.1 General Specifications

Lists key specifications such as bill insertion, dimensions, acceptance rate, protocols, and power.

3.0 MECHANICAL CONFIGURATION

3.1 Up stacker; Down stacker Configuration

Explains how to configure the ST1 for up or down stacking applications.

3.1.1 Faceplate Fitting; Removal

Provides instructions on how to fit and remove the faceplate.

3.2 Horizontal Stacker

3.2.1 Top Cover & Top Plate Assembly Fitting; Removal

Instructions for fitting and removing the top cover and plate assembly.

3.4.1 Cassette Fitting; Removal

4.0 INTERFACE PROTOCOLS

4.1 NAMA MDB

Information on using the GBA ST1 with the NAMA MDB interface.

4.2 ccTalk

Details on using the ccTalk interface and available harnesses.

4.3 USB

Explains the optional USB interface for connection and programming.

5.0 SOFTWARE CONFIGURATION

5.1 On-board Push Button

Details using the on-board push button for programming modes like note enable/disable.

5.1.1 Configuration Procedure - Enable Note

5.1.3 Configuration Procedure - Programming Card

5.1.4 Configuration Procedure - Re-Calibration

5.1.5 Calibration Error Codes

5.2 PC Based GBA Tools

5.2.1 Configuration Procedure - GBA Talk PC Software

5.3 USB Mass Storage Device

5.3.1 Connecting a USB Mass Storage Device

5.3.3 Sequence of events

5.3.4 USB Download Error codes

5.4 Software Configuration Options

Interface

ccTalk Encryption Key Reset

6.0 MECHANICAL INSTALLATION

7.0 ELECTRICAL INTERFACE SPECIFICATION

7.1 Power

7.2 Signal Interface

7.3 Low Power Mode

7.3.1 Electrical Connections

7.3.2 Operational Features

8.0 ELECTRICAL CONNECTIONS

9.0 MAINTENANCE

9.1 Cleaning the Validator Note Path

9.2 Clearing a Note Jam

9.3 Replacing Drive Belts

10.0 DIAGNOSTICS & TROUBLESHOOTING

10.1 Diagnostics

10.1.1 Diagnostic LED - Bottom Sensor Assembly

10.1.3 Diagnostic LED - Note Reject Codes

10.2 Troubleshooting

GBA ST1 Specifications

General

Counting Speed	2, 700 coins/minute
Hopper Capacity	6, 000 coins
Display	LCD
Power Supply	AC 110V/60Hz or 220V/50Hz
Dimensions	320mm x 320mm x 260mm
Weight	8.8 kg