GCC Technologies EP-60 - Page 17

Expert Pro User Manual
Installation 2-7
Step 5
Insert the roll holder support with the screws into the holes of the stand, and
then tighten them up as shown in Figure 2-9 . You could decide roll holder
support’s position by inserting into different holes.
Step 6
Place two roll holders onto the roll holder support and ensure the white
protrusion is wedged in the groove. ( Figure 2-10 )
3 screws
Roll holder
support
Figure 2-9
Roll holder support
Roll holder 1
Figure 2-10
Roll holder 2