GCC Technologies EP-60 - 2.6 Cable Connections; 2.6.1 USB Interface

Expert Pro User Manual
Installation 2-16
2.6 Cable Connections
Expert Pro communicates with a computer through USB (Universal Serial Bus)
or Serial port (RS-232C). This chapter shows you how to connect the cutting
plotter to a host computer and how to set up the computer/cutting plotter
interconnection.
!! Notice: When USB connection is enabled, serial port will be disabled
automatically.
2.6.1 USB Interface
Expert Pro build-in USB interface is based on the Universal Serial Bus
Specifications Revision 1.1. (Operation system of Windows 95, Windows NT
don’t support USB ).
 USB driver installation
Use the USB One-click Installation for quick driver installation. Follow the
simple steps below for driver setup.
Figure 2-19
USB port
Serial port
Caution!!
 If you are using Windows 8/ 7/ Vista/ XP/ 2000 as your
operating system, make sure you log in using the
“Administrator” account.