GCC Technologies EP-60 - 4.6 Reference Parameter setting for different materials

Expert Pro User Manual
Operation 4-12
4.6 Reference Parameter setting for different materials
The following reference parameter is used on GCC verified materials shown in the
table.
Material Wall stickers Magnets Protective tint
Blade red green green
Blade tip length (mm) 0.3 0.8 0.3
Force (g) 95 580 320
Speed (cm/sec) 72 3 3
Offset (mm) 0.275 0.5 0.5
Recommend model RX, Jaguar RX, Jaguar
RX, Jaguar, Puma, Bengal, Sable,
Ex Pro, Ex 24/52, Ex 24/52 LX
Material Vehicle stickers Reflective film Cardboard
Blade red green green
Blade tip length (mm) 0.27 0.5 0.3
Force (g) 85 380 165
Speed (cm/sec) 60 3 30
Offset (mm) 0.275 0.5 0.5
Recommend model
RX, Jaguar, Puma,
Bengal, Sable, Ex Pro
,
Ex 24/52, Ex 24/52 LX
RX, Jaguar, Puma,
Bengal, Sable, Ex Pro,
Ex 24/52, Ex 24/52 LX
RX, Jaguar, Puma, Bengal, Sable,
Ex Pro, Ex 24/52, Ex 24/52 LX
Material Window tint Window decoration
Personalized
stickers
Rhinestone
Blade red red red green
Blade tip length (mm) 0.09 0.25 0.28 0.8
Force (g) 70 95 105 190
Speed (cm/sec) 72 65 72 15
Offset (mm) 0.275 0.275 0.275 0.5
Recommend model RX, Jaguar RX, Jaguar RX, Jaguar
RX, Jaguar IV,
Puma III