GCC Technologies EP-60 - 3.3 Menu in Off-line Mode

Expert Pro User Manual
The Control Panel 3-3
3.3 Menu in Off-line Mode
Press [ON/OFF LINE] to switch to the offline mode
Offline For
System Setup
Force: 80 gf
OK:ENTER
5~400 with an increment of 5(gram force)
[ OFFSET ]
Offset: 0.275 mm
OK:ENTER
0.000~1.000 with an increment of 0.025(mm)
[ DATA CLEAR ]
Clear Data Memory
N:Cancel OK:ENTER
move origin
X: Y:
[ ]
[ SPEED ]
Speed: 51 cm/s
Select: OK:ENTER Speed:3~60 with an increment of 3(cm/s)
UP Speed: 51 cm/s
Select: OK:ENTER UP Speed :3~60 with an increment of 3(cm/s)
Quality: Fine
Select: OK:ENTER
Draft, Normal, Fair, Fine
[ FORCE ]
Turn CW , Turn CCW
Pattern Setting
Select: OK:ENTER
Square Cut
Select: OK:ENTER
Repeat Last Plot
Select: OK:ENTER
Pattern: Arrow
Change: OK: ENTER
Ratio Setting
Select: OK:ENTER
Ratio: 100%
Change: OK: ENTER
Blade Length Adjust
Select: OK:ENTER
Set Length 0.00mm
Change: OK: ENTER
Test Blade Holder
OK: ENTER
[CUT TEST ]
Ratio: 100%, 200%, 300%, 400%
Pattern: Cross, Arrow
Test Blade Length
OK: ENTER