GCC Technologies EP-60 - Page 40

Expert Pro User Manual
The Control Panel 3-4
Set Smoothing Cut
Select: OK:ENTER
OverCut:
0.00mm
Select: OK:ENTER
1S:51 F:80 O:0.275 M
Select: OK:ENTER
Set Tangential Mode
S
elect
:
OK
:ENTER
Panel Setup
S
elect
:
OK
:ENTER
Restore default ?
S
elect
OK
:ENTER
Save parameter ?
S
elect
:
OK
:ENTER
OverCut:0.00-1.00mm with an
increment
of
0.05mm
[TOOL SELECT ]
[ MISC ]
Offline For
System Setup
Vacuum
S
elect
:
OK
:ENTER
Image Scale Width
Select: OK:ENTER
Image Scale Length
Select: OK:ENTER
Select Unit
Select: OK:ENTER
Select Language
Select: OK:ENTER
Set Communication
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
Both Expanded Mode、Length Expanded Mode、
Width Expanded Mode、Both Unexpanded Mode
English,Spanish,Italian,Deutsch,Japanese,Portugue
se,Polish,Turkish,French
Metric (cm/gram) or English measurement (inch/oz)
or Unit (cm/oz) or Unit (inch/gram)
Auto Unrolled Media
Select: OK:ENTER
Firmware： x.x.xx
FPGA
：
Vx.x mm/dd/yy
Scale Width
Select: OK:ENTER
Scale Width
Select: OK:ENTER
Rear Paper Sensor
Select: OK:ENTER
Enable, Disable