Puma II User’s Guide 2-5
2-3 Power and cable Connection
! Notice
Check the plug of the power cord to see if it mates with the wall outlet. If not, please
contact with your dealer
Be sure that the power to both the computer and the main unit is switched off when
connecting the cable
! Warning Connecting the Power Supply
Ground the unit with the ground wire.
Insert the plug (male) into a grounded power outlet.
Insert the other end (female) of power cord into the AC connector of the cutting
plotter
.
Securely connect the power cord, Computer I/O cable and so on so that they
will not be unplugged and cause failure during operation.
Connect the cable to either the parallel or the serial port.
To Next Page
Loading...
