Puma II User’s Guide 2-20
damaging your blade.
** Procedures to repeat cutting job at different position:
1. After cutting finishes, use the ARROW keys to move the tool carriage. Move to your
desired position for repeating the cutting job, then press the ORIGIN SET key. The
ORIGIN SET LED lights, and new origin point is set.
2. Press the REPEAT key to repeat the cutting job, and the REPEAT LED lights.
2.12 DATA CLEAR Key
The purpose of the DATA CLEAR key is to clear the data in the buffer memory. The
DATA CLEAR key can only works under pause or off-line condition. When use this
function, the DATA CLEAR LED will light.
2.13 Origin Setting
Use the ORIGIN SET key to set a new origin at any position in the cutting area where
the tool carriage starts to work. Please note new origin setting must be made under the
off-line condition
.
Procedures :
1. After loading the media and lowering down the level, use ARROW keys to move the
carriage to the desired location for a new origin.
2. Press ORIGIN SET key and the original point is set. The ORIGIN SET LED lights.
To Next Page
