Puma II User manual 5-1
C
C
C
h
h
h
a
a
a
p
p
p
t
t
t
e
e
e
r
r
r
5
5
5
Basic Maintenance
This chapter explains the basic maintenance (i.e. cleaning the cutting plotter) required
for the cutting plotter. Except for the below mentioned, all other maintenance must be
performed by a qualified service technician.
5.1 Cleaning the Cutting Plotter
In order to keep the cutting plotter under good condition and best performance, you
need to clean the machine properly and regularly.
Precaution in Cleaning
Recommended Methods
!
Gently wipe the cutting plotter surface with a lint-free cloth. If necessary,
clean with a damp cloth or an alcohol-immersed cloth. Wipe with water to
rinse off any residue and dry with a soft, lint-free cloth.
! Wipe all dust and dirt from the tool carriage rails.
! Use a vacuum cleaner to empty any accumulated dirt and media residue beneath
the pinch roller housing.
! Clean the platen, paper sensors and pinch rollers with a damp cloth or an
alcohol-immersed cloth, and dry with a soft, lint-free cloth.
! Wipe dust and dirt from the stand.
5.2 Cleaning the Grid Drum
#
Unplug the cutting plotter before cleaning
#
Never use
solvents, abrasive cleaners or strong
detergents
for cleaning. They may damage the surface o
To Next Page
Loading...
