Puma II User’s Guide 2-19
2.9 ON/OFF LINE Key
**On - line
When the machine is in “ON LINE ” condition. The ON/OFF LINE LED is on. The cutting
plotter is ready to receive data from the host computer. At this moment, only “PAUSE”
and “ON/OFF LINE” keys are valid.
**Change the setting value
1. Press the PAUSE key. Then switch the dip to change the setting value.
2. Press the ON/OFF LINE key to effect new setting and continue cutting.
Note :
The parameters of dip switch can not be changed while the cutting has started
unless pressing the “PAUSE” key. When press the “PAUSE” key, you can change
the setting.
**Terminate the cutting & clear the data in the buffer
1. Press the ON/OFF LINE or PAUSE key
2. Then press the DATA CLEAR key
**Off - line
When the machine is in “OFF LINE” condition, the ON/OFF LED turn off. At this
moment, you can switch dip setting, make cutting test to adjust blade pressure and set
new origin. Press the key again will let the cutting plotter switch back to “ON LINE”
condition, and resume the suspended operation. But there might be some data loss during
this interruption.
2.10 PAUSE Key
The purpose of the “PAUSE” key is to temporarily terminate the motion of the cutter after
it started cutting. At this moment, the ON/OFF LINE LED flash; you can change the dips
switch setting and the cutting force. It will resume cutting after pressing the ON/OFF
LINE key to make the machine in on-line status.
2.11 Repeat Key
You can cut your last cutting job at the same position by pressing REPEAT key without
setting new origin. If you’re using a thicker media, it is better to use this function to avoid
To Next Page
Loading...
