Puma II User’s Guide 2-17
SW-5 : QUALITY
There is a trade-off between cutting quality and speed, the better the cutting quality, the
slower the cutting speed.
SW-6 : SMOOTH
Make the curves smoother during cutting.
**When cut the small letter, please set smooth disabled to cutting quality smooth setting.
SW-7 : AUTO UNROLL
Unroll the heavy media at least 50 cm when the next point of movement is located
beyond the unrolled position. As the media type is Single, this function will be
disabled.
SW-8 : MEDIA TYPE
Set the type of the media you use. When using a piece media, set it to “ON”; and set it to
“OFF” when using a roll media.
Fine quality
Draft quality
Single sheet of media is using.
A roll of media is using.
Disable the smoothing cut.
Enable the smoothing cut.
Disable the auto unroll
Enable the auto unroll
To Next Page
