GE AKTA GO - Space Requirements

4.1.2 Space requirements
Introduction
This section describes the requirements for the laboratory bench on which the ÄKTA go
is placed.
WARNING
Access to power plug. Do not block access to the power outlet
and power plug. The power cord with plug must always be easy
to disconnect.
Laboratory bench
The bench must be clean, flat and stable, and of sufficient size for the ÄKTA go system
with accessories. The computer is located on the right side of the instrument to make
room for accessories on the left side of the instrument.
Run
ÄKTA go Operating Instructions 29360951 AC 35
4 Installation
4.1 Site preparation
4.1.2 Space requirements