GE AKTA pilot 600 - 3.11 pH monitor (optional)

3.11 pH monitor (optional)
Introduction
This section describes the optional pH monitor module. The module is used to continu-
ously measure the pH of solutions used in the run.
Illustration
The illustration below shows the front of the pH monitor module.
5
1
2
3
4
DescriptionPart
Dummy electrode1
pH electrode in storage position2
Inlet port3
Manual injection port4
Outlet port5
ÄKTA pilot 600 User Manual 29274559 AA 55
3 Description of modules
3.11 pH monitor (optional)