DescriptionFractionation
type
Outflow will be directed to the specified outlet position until
fractionation ends.
Note:
Make sure that Stop fractionation at the end of this phase is
checked in the current or a subsequent phase as appropriate,
to avoid directing all subsequent outflow to the specified outlet
position.
Fixed outlet
Advanced settings
Advanced settings determines the maximum number of fractions that will be collected.
Any outflow after the maximum number of fractions has been collected will be directed
to Outlet 1-Waste.
Check Use all available outlets to use all the outlet positions installed on the instrument
except for Outlet 1-Waste.
Alternatively, remove the checkmark and enter the maximum number of fractions.
Peak fractionation settings
Peak Frac Settings determine the conditions for peak detection.
ÄKTA pilot 600 User Manual 29274559 AA 73
4 Operation
4.2 Fractionation
To Next Page
Loading...
