Viewing stored patient data
2001989-200E ApexPro™ 8-19
NOTE
You can also use the left or right mouse buttons to click on the
waveform to move the left or right caliper arm to this position.
6. Click Apply to calculate the measurement. The measurement result displays in
the measurement table.
7. Repeat step 4 to step 6 to calculate other measurements.
8. To print with the measurements, click (print button) located in the top right
corner of the Calipers window. All measurements are lost when the window is
closed.
Reports
The following reports are available for telemetry patients if a laser printer is
configured for the CIC Pro center. These reports are enabled and configured through
Webmin. For more information, refer to the appropriate CIC Pro center service
manual.
Patient discharge summary report
The Patient Discharge Summary report automatically prints to a configured laser
printer for the CIC Pro center when a telemetry patient is discharged. The report
provides general patient, system status alarm and patient status alarm information.
NOTE
Contact biomed/service department for configuration of laser printer for patient
discharge summary report.
To Next Page
Loading...
