Turning off the system
1. Perform the "End a case" procedure, if appropriate.
2. Push and hold the On/Standby switch for 1 second.
3. Select Confirm or push the ComWheel within 10 seconds to
turn off the system.
If no action is performed within 10 seconds, the screen
automatically returns to the previous display.
When the system is in a complete system failure state, the On/
Standby switch may be pushed and held in for 10 seconds to
shut down the system. If On/Standby switch does not shut down
the system, unplug the AC power cord from the electrical outlet
to force the system to shut down, and contact an authorized
service representative.
Wait a minimum of 5 seconds after the keypad lighting turns off
before restarting the system.
Note
Note
3 Operation
2076152-001 3-13
To Next Page
Loading...
