CB Watch 3 User Manual v6.3 - May 2019 Page 60 of 100
Coil Current Alarm
An alarm can be set on a maximum threshold for the mean current used to actuate each
coil (both during opening and during closing, if the coils are different):
HMI: Settings / Analog channels
Figure 92 – Maximum mean current threshold settings
The resulting alarms are displayed in the HMI:
HMI: Measurements / Alarms
Figure 93 – Coil charge alarms
Coil Charge Alarm
Alarms thresholds can be set during setup on:
• Minimum and maximum coil charge when opening
• Minimum and maximum coil charge when closing
HMI: Settings / Analog channels
Figure 94 – Coil charge threshold settings
The resulting alarms are displayed in the HMI:
HMI: Measurements / Alarms
Figure 95 – Coil charge alarms
To Next Page
Loading...
