CB Watch 3 User Manual v6.3 - May 2019 Page 74 of 100
The curves are stored and previous curves can be retrieved and displayed via the HMI:
Figure 122 – Drop-down list of previous archives
The maximum pump motor current (peak inrush current) is displayed in the HMI:
HMI: Measurements / Pump
Figure 123 – Maximum inrush current
Pump motor current alarm
An alarm can be set on the maximum inrush current value of the pump motor by setting
the “Max threshold” value.
HMI: Settings / Analog channels
Figure 124 – Pump motor inrush current maximum threshold setting
The alarm is displayed when the threshold has been reached:
HMI: Measurement / Alarms
Figure 125 – Pump motor inrush current alarm
To Next Page
Loading...
