Chapter 2: Installation
Concord 4 Installation Manual 11
Grounding the panel
For maximum protection from lightning strikes and transients, connect the enclosure
to earth ground as shown in Figure 3 below. Use 16-gauge, solid copper wire from an
earth grounded cold water pipe clamp to the enclosure.
Figure 3: Grounding the panel
Grounding wire
Water pipe
Grounding clamp
Note: For best results, we recommend that you crimp a spade lug on the wire end at
the panel and secure the lug to the enclosure.
Antenna shrouds
Install a plastic antenna shroud (included with panel) over each antenna and snap
them into the holes on the top of the enclosure (skip this step for hybrid and
commercial systems).
To Next Page
Loading...
