GE Concord 4 Installation Manual

Chapter 3: Programming
82 Concord 4 Installation Manual
Direct bypassing
Shortcut: 030nnn1,
where nnn is user
number 00 to 229
Default: Off
This setting determines whether a specific user code provides access to the
bypass sensors feature. Set this feature to on for all users who need to be
able to bypass sensors.
To turn the direct bypassing setting off or on:
1. With the display showing USER CODES, press # and the display shows
REGULAR USER CODES.
2. Press # and the display shows USER nnn (first available user number).
3. Press A or B to select the desired user number, then press #. The display
shows USER nnn - nnnn.
4. Press A or B until the display shows DIRECT BYPASSING OFF/ON
(current setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and
the display shows the new setting.
Remote access
Shortcut: 030nnn2,
where nnn is user
number 000 to 229
Default: Off
This setting determines whether the user can access the panel from a
remote phone (a phone located off the premises).
To turn the remote access setting off or on:
1. With the display showing USER CODES, press # and the display shows
REGULAR USER CODES.
2. Press # and the display shows USER nn (first available user number).
3. Press A or B to select the user number, then press #. The display shows
USER nnn - nnnn.
4. Press B until the display shows REMOTE ACCESS ON/OFF (current
setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and
the display shows the new setting.
System tests
Shortcut: 030nnn3,
where nnn is user
number 000 to 229
Default: Off
This setting determines whether a specific user code provides access to the
phone and sensor tests. Set this feature to on for all users who need to be
able to conduct phone and sensor tests.
To turn the system tests setting off or on:
1. With the display showing USER CODES, press # and the display shows
REGULAR USER CODES.
2. Press # and the display shows USER nn (first available user number).
3. Press A or B to select the user number, then press #. The display shows
USER nnn - nnnn.
4. Press A or B until the display shows SYSTEM TESTS OFF/ON (current
setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and
the display shows the new setting.

GE Concord 4 Specifications

General

Zones	96
Partitions	6
User Codes	230
Power Supply	16.5 VAC, 40 VA
Wireless Compatibility	Compatible with GE wireless sensors
Keypads	Up to 8
Outputs	2 onboard, expandable
Event Log	512 events
Backup Battery	12VDC, 7AH
Communication	Phone line, optional cellular or IP